Single From a cost perspective, if the hollow glass bubbles per unit mass of the same price, you should use the lowest possible density of hollow glass microspheres, so low unit cost.If just from a performance standpoint, because the larger the lower the density of the hollow glass microspheres diameter, large diameter also reduces the conductivity between the zinc coating, which reduces the resistance to salt spray paint, and therefore should be chosen particle size as small as hollow glass microspheres.There are on the one hand I must mention that, due to the formulation of other fillers such as zinc and iron phosphate high density, when the coating solution is stirred crashed hollow glass microspheres, and in the spray when a low intensity hollow glass microspheres are easily broken failure. Therefore, the density of the microspheres can not be selected too large, the particle size can not be too large, and the strength is sufficient.
Proposal to add the following methods:
In order to take full advantage of the characteristics of the hollow microspheres, recommended adding a last resort, that is added to the beads into the final as low speed mixing equipment dispersed using low shear force, because the spherical beads mobility well, between the friction is not large, so it is easy to disperse. You can complete a short wet, slightly extended mixing time to achieve uniform dispersion.
Beads chemically inert, non-toxic. However, because of a very light, so they need special attention added.Recommended stepwise addition method, which is the amount for each remaining 1/2 beads gradually added, this can be good to avoid beads float into the air and dispersed more complete.
Sinosteel Maanshan New Material Technology Co., Ltd.
